Does the EPS provide support for a wood sill plate?
No, the EPS has no struc­tur­al capac­i­ty to sup­port any loads. Wood sill plates must achieve the required bear­ing from the con­crete with­in the ICF. A wood plate that can­tilevers 13 over the EPS and bears 23 on the con­crete is allow­able. This can be done with a min­i­mum 2 x 6 plate. If a 24 plate is required, a taper top form should be used to extend the con­crete under the plate.
Can I leave Fox Blocks forms exposed to ultraviolet rays for an extended period (months)?
Yes, but you will notice a light dust­ing on the sur­face and a yel­low­ing dis­col­oration of the forms. This does not indi­cate any detri­men­tal effects to the ICFs. We do sug­gest, that if the exte­ri­or fin­ish is not going to be installed with­in around a 3 month peri­od or more, the forms be pro­tect­ed from UV rays by installing a tem­po­rary build­ing wrap type mate­r­i­al. The pow­dery film must be removed with soap and water before the appli­ca­tion of a syn­thet­ic stuc­co fin­ish or water­proof­ing mem­brane.
What is a ‘blow-out’?

A blow-out’ is a break in the form, gen­er­al­ly due to the pres­sure from the liq­uid con­crete dur­ing the con­crete place­ment and/​or con­sol­i­da­tion. Fox Blocks ICFs are designed to main­tain a high safe­ty fac­tor of pres­sure from the liq­uid con­crete. Dam­aged forms or fail­ure to sup­port areas where forms have been cut leav­ing a large area of EPS between the web sup­ports may cause a blow-out. Over con­sol­i­da­tion may also cause a blow-out.

Fox Blocks rec­om­mends the Pre-Place­ment Check­list be reviewed for all wall assem­blies pri­or to the place­ment of con­crete, to find poten­tial prob­lem areas and install addi­tion­al strap­ping or sup­port to pre­vent blow-outs. Gen­er­al­ly, for an Fox Blocks form, the size of a blow-out may be lim­it­ed to the EPS between the webs, 6″ or 8″ wide by the height of one form. If a blow-out occurs, the con­crete pour moves to anoth­er area on the wall, the hole is patched by replac­ing the EPS, installing wood sup­port over the area, and then resum­ing the pour.