Filter by
All
Resources
Case Studies
Blog
FAQs
What is the typical Interior finish on an ICF?

All build­ing codes in the USA and Cana­da spec­i­fy that plas­tic insu­la­tion (EPS) must be cov­ered by a ther­mal bar­ri­er equiv­a­lent to 15 min­utes of fire pro­tec­tion in hab­it­able spaces. This is achieved with ½” gyp­sum board or an equiv­a­lent mate­r­i­al. Fox Blocks has spe­cif­ic fire test­ing that proves reg­u­lar ½” gyp­sum board with reg­u­lar dry­wall screws fas­tened into the plas­tic webs remains on the wall for the required 15-minute time peri­od.

VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Is there a top and bottom on the blocks when installing the Fox Blocks forms?
Fox Blocks forms have a reversible inter­lock sys­tem on all blocks. The robust inter­lock allows the blocks to fit togeth­er very tight­ly, elim­i­nat­ing any require­ment for adhe­sives. A reversible inter­lock speeds up the instal­la­tion.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Can I install a 16' garage door and / or large openings in a concrete wall?
Yes, if the fol­low­ing cri­te­ria is avail­able for the design of a con­crete lin­tel (beam) over the open­ing – con­crete lin­tel depth min­i­mum 16″ (400 mm) or more with no point loads. Larg­er open­ings would require an engi­neered design.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
What do termites do to the foam?
EPS pro­vides no nutri­ent val­ue and is not a food source for ter­mites. If left exposed, ter­mites may tun­nel into the foam in search of fibrous food. When build­ing, in a heavy ter­mite infes­ta­tion area, care is required in the detail­ing and con­struc­tion of the walls that will be in con­tact with ground, to pre­vent access to the foam for ter­mites.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
What fasteners are recommended for ICFs?

Fox Blocks has con­duct­ed numer­ous fas­ten­er tests for pull-out strength and shear capac­i­ty for var­i­ous fas­ten­ers – screws, ring shank nails and sta­ples into the plas­tic webs. The rec­om­men­da­tion for inte­ri­or and exte­ri­or appli­ca­tions of fin­ish mate­ri­als is for the use of screws which pro­vide the best hold­ing capac­i­ty into the plas­tic webs or fas­ten­ing strips in the forms which are iden­ti­fied on each block.

The EPS insu­la­tion does not pro­vide any hold­ing capac­i­ty for fas­ten­ers.

VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Can you vibrate or consolidate the concrete in ICFs?
Yes, con­sol­i­da­tion of the con­crete is one of the key ele­ments in the place­ment of con­crete in an ICF wall. Fox Blocks rec­om­mends inter­nal vibra­tion with a pen­cil vibra­tor, quick­ly in and slow­ly out.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
What exterior finishes can be used on an ICF?
Fox Blocks are com­pat­i­ble with all exte­ri­or fin­ish mate­ri­als and sys­tems – sid­ing, stuc­co, mason­ry veneer, sim­u­lat­ed stone, etc. The attach­ment of cer­tain exte­ri­or fin­ish­ing sys­tems is rec­om­mend­ed with exte­ri­or grade screws fas­tened into the exposed or con­cealed webs.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Can masonry be installed on the exterior walls?
Yes, Fox Blocks has a brick ledge form and the xLer­a­tor ledge rein­force­ment that is designed to sup­port mason­ry. Fox blocks also has a tieKey acces­so­ry which is a specif­i­cal­ly made as a mason­ry tie, to be insert­ed through the form into the con­crete.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
What is EPS made from?
Poly­styrene is vir­gin mate­r­i­al, man­u­fac­tured from petro­le­um. Poly­styrene beads are expand­ed with steam heat to be up to 40 times their orig­i­nal vol­ume and then the expand­ed beads are mold­ed again by steam heat into 25⁄8″ rigid insu­la­tion pan­els to cre­ate a Fox Blocks ICF.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow
Is the Fox Blocks ICF product ‘LEED’ rated or certified?
Prod­ucts are not rat­ed or cer­ti­fied under the LEED pro­gram. The over­all build­ing is eval­u­at­ed and assigned a LEED rat­ing. In the selec­tion of build­ing mate­ri­als for a LEED design, Fox Blocks have many ben­e­fits that can enable, enhance or direct­ly con­tribute toward LEED points for the project.
VIEW PAGE
Arrow1 right shadowLong arrow right with shadow